Network Router User Manual

Attach to Your Network Using Ethernet Cabling
7
3. Power on: Connect the power adapter to the Router.
Figure 3-1. Connecting the EZ-Stream Wireless Router
3.1 | Attach to Your Network Using Ethernet Cabling
The four LAN ports on the Router auto-negotiate the connection
speed to 10 Mbps Ethernet or 100 Mbps Fast Ethernet, and the
transmission mode to half duplex or full duplex.
Use twisted-pair cable to connect any of the four LAN ports on the
Router to an Ethernet adapter on your PC. Otherwise, you can
cascade any of the LAN ports on the Router to an Ethernet hub or
switch, and then connect your PC or other network equipment to the
hub or switch. When inserting an RJ-45 plug, be sure the tab on the
plug clicks into position to ensure that it is properly seated.
Warning: Do not plug a phone jack connector into any RJ-45
port. This may damage the Router. Instead, use only
twisted-pair cables with RJ-45 connectors that
conform with FCC standards.
Internet
Internet
Access
Device
SMC2304WBR-AG
Wireless Gateway
SOHO Office or Residence