Fast Ethernet Switch User Guide

TROUBLESHOOTING
1.
SSyymmppttoomm
Power LED does not light after power on
Probable cause
Power outlet or power cord may be defective
Possible Solutions
. Check for loose connections.
. Check the power outlet by using it for another device.
. Replace the power cord.
2.
SSyymmppttoomm
Link LED does not light after connection is made.
Probable Causes
Switch port, network card or cable may be defective.
Possible Solutions
. Check that the switch and attached device are both powered
on.
. Be sure the network cable is connected to both devices
. Verify that Category 5 cable is used for 100Mbps connections
and that the length of any cable does not exceed 100 meters
(328 feet). Check the network card and cable connections for
defects.
. Replace the defective card or cable if necessary.