100Mbps Stackable Managed Switch Management Guide

OMMAND

INE

NTERFACE

4-176

mac-address-table static

This command maps a static address to a destination port in a VLAN. Use

the no form to remove an address.

Syntax

mac-address-table static mac-address interface interface

vlan vlan-id [action]

no mac-address-table static mac-address vlan vlan-id

• mac-address - MAC address.

• interface

- ethernet unit/port

-unit - Stack unit.

(Range – SMC6224M: 1-8, SMC6248M: 1-4, mixed stack: 1-4)

-port - Port number. (Range: 1-26/50)

- port-channel channel-id (Range: 1-4)

• vlan-id - VLAN ID (Range: 1-4094)

• action -

- delete-on-reset - Assignment lasts until the switch is reset.

- permanent - Assignment is permanent.

Default Setting

No static addresses are defined. The default mode is permanent.

Command Mode

Global Configuration

Command Usage

The static address for a host device can be assigned to a specific port

within a specific VLAN. Use this command to add static addresses to

the MAC Address Table. Static addresses have the following

characteristics:

• Static addresses will not be removed from the address table when a

given interface link is down.

• Static addresses are bound to the assigned interface and will not be

moved. When a static address is seen on another interface, the address

will be ignored and will not be written to the address table.