24/48-Port 10/100Mbps Stackable Managed Switch Management Guide

C ONFIGURING THE S WITCH
3-114
Web – Click Port, Rate Limit, Granularity. Select the required rate limit
granularity for Fast Ethernet and Gigabit Ethernet, and click apply.
Figure 3-50 Rate Limit Granularity Configuration
CLI - This example sets and displays Fast Ethernet and Gigabit Ethernet
granularity.
Rate Limit Configuration
Use the rate limit configuration pages to apply rate limiting.
Command Usage
Input and output rate limit can be enabled or disabled for individual
interfaces.
Command Attributes
• Port/Trunk – Displays the port number.
• Rate Limit Status – Enables or disables the rate limit. (Default:
Disabled)
• Rate Limit Level – Sets the rate limit level.
(Fast Ethernet – Range: 1-255: Default: 255;
Gigabit Ethernet – Range: 1-30: Default: 30)
Note: Actual rate limit = Rate Limit Level * Granularity
Console(config)#rate-limit fastethernet granularity 512 4-160
Console(config)#rate-limit gigabitethernet granularity 33300 4-160
console#show rate-limit 4-161
Fast ethernet granularity: 512
Gigabit ethernet granularity: 33300
Console#