24-Port Fast Ethernet Switch Management Guide

IP I NTERFACE C OMMANDS
4-280
IP Interface Commands
An IP addresses may be used for management access to the switch over your
network. The IP address for this switch is obtained via DHCP by default.
You can manually configure a specific IP address, or direct the device to
obtain an address from a BOOTP or DHCP server when it is powered on.
You may also need to a establish a default gateway between this device and
management stations or other devices that exist on another network
segment.
ip address
This command sets the IP address for the currently selected VLAN interface.
Use the no form to restore the default IP address.
Syntax
ip address {ip-address netmask | bootp | dhcp}
no ip address
• ip-address - IP address
• netmask - Network mask for the associated IP subnet. This mask
identifies the host address bits used for routing to specific subnets.
• bootp - Obtains IP address from BOOTP.
• dhcp - Obtains IP address from DHCP.
Table 4-73 IP Interface Command Syntax
Command Function Mode Page
ip address Sets the IP address for the current interface IC 4-280
ip
default-gateway
Defines the default gateway through which an
in-band management station can reach this device
GC 4-282
ip dhcp restart Submits a BOOTP or DCHP client request PE 4-282
show ip interface Displays the IP settings for this device PE 4-283
show ip redirects Displays the default gateway configured for this
device
PE 4-284
ping Sends ICMP echo request packets to another
node on the network
NE,
PE
4-284