24-Port Fast Ethernet Switch Management Guide

C OMMAND L INE I NTERFACE
4-261
map ip port (Global Configuration)
This command enables IP port mapping (i.e., class of service mapping for
TCP/UDP sockets). Use the no form to disable IP port mapping.
Syntax
[no] map ip port
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
The precedence for priority mapping is IP Port, IP Precedence or IP
DSCP, and default switchport priority.
Example
The following example shows how to enable TCP/UDP port mapping
globally:
map access-list mac Sets the CoS value and corresponding output
queue for packets matching an ACL rule
IC 4-147
show map ip port Shows the IP port map PE 4-266
show map ip
precedence
Shows the IP precedence map PE 4-267
show map ip dscp Shows the IP DSCP map PE 4-268
show map access-list
ip
Shows CoS value mapped to an access list for
an interface
PE 4-136
show map access-list
mac
Shows CoS value mapped to an access list for
an interface
PE 4-148
Console(config)#map ip port
Console(config)#
Table 4-66 Priority Commands (Layer 3 and 4)
Command Function Mode Page