24-Port Fast Ethernet Switch Management Guide

C OMMAND L INE I NTERFACE
4-203
Default Setting
None
Command Mode
Privileged Exec
Command Usage
• The MAC Address Table contains the MAC addresses associated with
each interface. Note that the Type field may include the following types:
- Learned - Dynamic address entries
- Permanent - Static entry
- Delete-on-reset - Static entry to be deleted when system is reset
• The mask should be hexadecimal numbers (representing an equivalent
bit mask) in the form xx-xx-xx-xx-xx-xx that is applied to the specified
MAC address. Enter hexadecimal numbers, where an equivalent binary
bit “0” means to match a bit and “1” means to ignore a bit. For example,
a mask of 00-00-00-00-00-00 means an exact match, and a mask of
FF-FF-FF-FF-FF-FF means “any.”
• The maximum number of address entries is 8191.
Example
mac-address-table aging-time
This command sets the aging time for entries in the address table. Use the no
form to restore the default aging time.
Syntax
mac-address-table aging-time seconds
no mac-address-table aging-time
seconds - Time in number of seconds (10-1000000, or 0 to disable
aging).
Default Setting
300 seconds
Console#show mac-address-table
Interface Mac Address Vlan Type
--------- ----------------- ---- -----------------
Eth 1/ 1 00-E0-29-94-34-DE 1 Delete-on-reset
Console#