24-Port Fast Ethernet Switch Management Guide

L INK A GGREGATION C OMMANDS
4-192
lacp system-priority
This command configures a port's LACP system priority. Use the no form to
restore the default setting.
Syntax
lacp {actor | partner} system-priority priority
no lacp {actor | partner} system-priority
• actor - The local side an aggregate link.
• partner - The remote side of an aggregate link.
• priority - This priority is used to determine link aggregation group
(LAG) membership, and to identify this device to other switches
during LAG negotiations. (Range: 0-65535)
Default Setting
32768
Command Mode
Interface Configuration (Ethernet)
Command Usage
• Port must be configured with the same system priority to join the same
LAG.
• System priority is combined with the switch’s MAC address to form the
LAG identifier. This identifier is used to indicate a specific LAG during
LACP negotiations with other systems.
Configuration:
Name:
Port admin: Up
Speed-duplex: Auto
Capabilities: 10half, 10full, 100half, 100full
Flow control: Enabled
Port security: Disabled
Max MAC count: 0
Current status:
Created by: LACP
Link status: Up
Port operation status: Up
Operation speed-duplex: 100full
Flow control type: None
Member Ports: Eth1/11, Eth1/12, Eth1/13,
Console#