24-Port Fast Ethernet Switch Management Guide

I NTERFACE C OMMANDS
4-170
Interface Commands
These commands are used to display or set communication parameters for
an Ethernet port, aggregated link, or VLAN.
Table 4-46 Interface Commands
Command Function Mode Page
interface Configures an interface type and enters interface
configuration mode
GC 4-171
description Adds a description to an interface configuration IC 4-171
speed-duplex Configures the speed and duplex operation of a
given interface when autonegotiation is disabled
IC 4-172
negotiation Enables autonegotiation of a given interface IC 4-173
capabilities Advertises the capabilities of a given interface for
use in autonegotiation
IC 4-174
flowcontrol Enables flow control on a given interface IC 4-175
shutdown Disables an interface IC 4-176
switchport
broadcast
packet-rate
Configures broadcast storm control IC 4-177
clear counters Clears the statistics on a given interface PE 4-178
show interfaces
status
Displays status for the specified interface NE,
PE
4-179
show interfaces
counters
Displays statistics for the specified interfaces NE,
PE
4-180
show interfaces
switchport
Displays the administrative and operational
status of an interface
NE,
PE
4-182