24-Port Fast Ethernet Switch Management Guide

A CCESS C ONTROL L IST C OMMANDS
4-148
Default Setting
None
Command Mode
Interface Configuration (Ethernet)
Command Usage
• You must configure an ACL mask before you can map CoS values to the
rule.
• By default, a packet matching a rule within the specified ACL is mapped
to one of the output queues as shown below.
Example
Related Commands
queue cos-map (4-257)
show map access-list mac (4-148)
show map access-list mac
This command shows the CoS value mapped to a MAC ACL for the current
interface. (The CoS value determines the output queue for packets matching
an ACL rule.)
Syntax
show map access-list mac [interface]
interface
ethernet unit/port
- unit - Stack unit. (Range: 1-8)
- port - Port number. (Range: 1-26)
Table 4-39 Mapping CoS Values to MAC ACL Rules
Queue 0123
Priority 1,2 3 4,5 6,7
Console(config)#int eth 1/5
Console(config-if)#map access-list mac M5 cos 0
Console(config-if)#