24-Port Fast Ethernet Switch Management Guide

C OMMAND L INE I NTERFACE
4-147
• If a port is already bound to an ACL and you bind it to a different ACL,
the switch will replace the old binding with the new one.
• You must configure a mask for an ACL rule before you can bind it to a
port.
Example
Related Commands
show mac access-list (4-142)
show mac access-group
This command shows the ports assigned to MAC ACLs.
Command Mode
Privileged Exec
Example
Related Commands
mac access-group (4-146)
map access-list mac
This command sets the output queue for packets matching an ACL rule. The
specified CoS value is only used to map the matching packet to an output
queue; it is not written to the packet itself. Use the no form to remove the
CoS mapping.
Syntax
[no] map access-list mac acl_name cos cos-value
• acl_name – Name of the ACL. (Maximum length: 15 characters)
• cos-value – CoS value. (Range: 0-7)
Console(config)#interface ethernet 1/2
Console(config-if)#mac access-group jerry in
Console(config-if)#
Console#show mac access-group
Interface ethernet 1/5
MAC access-list M5 out
Console#