24-Port Fast Ethernet Switch Management Guide

C OMMAND L INE I NTERFACE
4-89
boot system
Use this command to specify the file or image used to start up the system.
Syntax
boot system [unit:] {boot-rom| config | opcode}: filename
The type of file or image to set as a default includes:
• boot-rom* - Boot ROM.
• config* - Configuration file.
• opcode* - Run-time operation code.
• filename - Name of the configuration file or image name.
• unit* - Specifies the stack unit. (Range: 1-8)
* The colon (:) is required.
Default Setting
None
Command Mode
Global Configuration
Command Usage
• A colon (:) is required after the specified unit number and file type.
• If the file contains an error, it cannot be set as the default file.
Example
Related Commands
dir (4-87)
whichboot (4-88)
Console(config)#boot system config: startup
Console(config)#