24-Port Fast Ethernet Switch Management Guide

C OMMAND L INE I NTERFACE
4-73
clock timezone
This command sets the time zone for the switch’s internal clock.
Syntax
clock timezone name hour hours minute minutes {before-utc |
after-utc}
• name - Name of timezone, usually an acronym.
(Default: UTC; Range: 1-29 characters)
• hours - Number of hours before UTC (0-12) or after UTC (0-13).
• minutes - Number of minutes before/after UTC. (Range: 0-59
minutes)
• before-utc - Sets the local time zone before (west) of UTC.
• after-utc - Sets the local time zone after (east) of UTC.
Default Setting
None
Command Mode
Global Configuration
Command Usage
This command sets the local time zone relative to the Coordinated
Universal Time (UTC, formerly Greenwich Mean Time or GMT), based
on the earth’s prime meridian, zero degrees longitude. To display a time
corresponding to your local time, you must indicate the number of hours
and minutes your time zone is east (before) or west (after) of UTC
Example
Related Commands
show sntp (4-72)
Console(config)#clock timezone Pacific hours 8 minute 0 before-UTC
Console(config)#