24-Port Fast Ethernet Switch Management Guide

S YSTEM M ANAGEMENT C OMMANDS
4-64
Example
The following example shows the event message stored in RAM.
SMTP Alert Commands
Configures SMTP event handling, and forwarding of alert messages to the
specified SMTP servers and email recipients.
logging sendmail host
This command specifies SMTP servers that will be sent alert messages. Use
the no form to remove an SMTP server.
Syntax
[no] logging sendmail host ip_address
ip_address - IP address of an SMTP server that will be sent alert
messages for event handling.
Console#show log ram
[1] 00:01:30 2001-01-01
"VLAN 1 link-up notification."
level: 6, module: 5, function: 1, and event no.: 1
[0] 00:01:30 2001-01-01
"Unit 1, Port 1 link-up notification."
level: 6, module: 5, function: 1, and event no.: 1
Console#
Table 4-21 SMTP Commands
Command Function Mode Page
logging sendmail host SMTP servers to receive alert messages GC 4-64
logging sendmail
level
Severity threshold used to trigger alert
messages
GC 4-65
logging sendmail
source-email
Email address used for “From” field of alert
messages
GC 4-66
logging sendmail
destination-email
Email recipients of alert messages GC 4-67
logging sendmail Enables SMTP event handling GC 4-67
show logging
sendmail
Displays SMTP event handler settings NE,
PE
4-68