24-Port Fast Ethernet Switch Management Guide

C OMMAND L INE I NTERFACE
4-37
Related Commands
enable (4-25)
authentication enable (4-99)
IP Filter Commands
management
This command specifies the client IP addresses that are allowed management
access to the switch through various protocols. Use the no form to restore
the default setting.
Syntax
[no] management {all-client | http-client | snmp-client |
telnet-client} start-address [end-address]
• all-client - Adds IP address(es) to the SNMP, web and Telnet groups.
• http-client - Adds IP address(es) to the web group.
• snmp-client - Adds IP address(es) to the SNMP group.
• telnet-client - Adds IP address(es) to the Telnet group.
• start-address - A single IP address, or the starting address of a range.
• end-address - The end address of a range.
Default Setting
All addresses
Command Mode
Global Configuration
Table 4-11 IP Filter Commands
Command Function Mode Page
management Configures IP addresses that are allowed
management access
GC 4-37
show management Displays the switch to be monitored or
configured from a browser
PE 4-38