24-Port Fast Ethernet Switch Management Guide

C ONFIGURING THE S WITCH
3-232
CLI - This example sets a default domain name and a domain list.
However, remember that if a domain list is specified, the default domain
name is not used.
Configuring Static DNS Host to Address Entries
You can manually configure static entries in the DNS table that are used to
map domain names to IP addresses.
Command Usage
• Static entries may be used for local devices connected directly to the
attached network, or for commonly used resources located elsewhere on
the network.
• Servers or other network devices may support one or more connections
via multiple IP addresses. If more than one IP address is associated with
a host name in the static table or via information returned from a name
server, a DNS client can try each address in succession, until it establishes
a connection with the target device.
Field Attributes
• Host Name – Name of a host device that is mapped to one or more IP
addresses. (Range: 1-64 characters)
• IP Address – Internet address(es) associated with a host name.
(Range: 1-8 addresses)
Console(config)#ip domain-name sample.com 4-288
Console(config)#ip domain-list sample.com.uk 4-289
Console(config)#ip domain-list sample.com.jp
Console(config)#ip name-server 192.168.1.55 10.1.0.55 4-290
Console(config)#ip domain-lookup 4-291
Console#show dns 4-293
Domain Lookup Status:
DNS enabled
Default Domain Name:
.sample.com
Domain Name List:
.sample.com.uk
.sample.com.jp
Name Server List:
192.168.1.55
10.1.0.55
Console#