24-Port Fast Ethernet Switch Management Guide

C ONFIGURING THE S WITCH
3-114
CLI – This example assigns an IP and MAC ingress ACL to port 1, and an
IP ingress ACL to port 2.
Port Configuration
Displaying Connection Status
You can use the Port Information or Trunk Information pages to display
the current connection status, including link state, speed/duplex mode,
flow control, and auto-negotiation.
Command Attributes (Web)
• Name – Interface label.
• Type – Indicates the port type. (100BASE-TX, 1000BASE-GBIC,
100BASE-FX-S, 100BASE-FX-M, 1000BASE-T, or SFP)
• Admin Status – Shows if the interface is enabled or disabled.
• Oper Status – Indicates if the link is Up or Down.
• Speed Duplex Status – Shows the current speed and duplex mode.
(Auto, or fixed choice)
• Flow Control Status – Indicates the type of flow control currently in
use. (IEEE 802.3x, Back-Pressure or None)
• Autonegotiation – Shows if auto-negotiation is enabled or disabled.
• Trunk Member
4
– Shows if port is a trunk member.
• Creation
5
– Shows if a trunk is manually configured or dynamically set
via LACP.
Console(config)#interface ethernet 1/1 4-171
Console(config-if)#ip access-group david in 4-134
Console(config-if)#mac access-group jerry in 4-146
Console(config-if)#exit
Console(config)#interface ethernet 1/2
Console(config-if)#ip access-group david in
Console(config-if)#
4. Port Information only.
5. Trunk Information only.