Gigabit Ethernet Switch Management Guide

C LASS OF S ERVICE C ONFIGURATION
3-189
Command Attributes
• Priority – CoS value. (Range: 0-7, where 7 is the highest priority)
• Traffic Class
11
– Output queue buffer. (Range: 0-7, where 7 is the
highest CoS priority queue)
Web – Click Priority, Traffic Classes. Assign priorities to the traffic classes
(i.e., output queues), then click Apply.
Figure 3-84 Traffic Classes
CLI – The following example shows how to change the CoS assignments
to a one-to-one mapping.
Note: Mapping specific values for CoS priorities is implemented as an
interface configuration command, but any changes will apply to
the all interfaces on the switch.
11. CLI shows Queue ID.
Console(config)#interface ethernet 1/1 4-174
Console(config-if)#queue cos-map 0 0 4-263
Console(config-if)#queue cos-map 1 1
Console(config-if)#queue cos-map 2 2
Console(config-if)#end
Console#show queue cos-map ethernet 1/1 4-266
Information of Eth 1/1
CoS Value: 0 1 2 3 4 5 6 7
Priority Queue: 0 1 2 3 4 5 6 7
Console#