Gigabit Ethernet Switch Management Guide

C OMMAND L INE I NTERFACE
4-276
Multicast Filtering Commands
This switch uses IGMP (Internet Group Management Protocol) to query
for any attached hosts that want to receive a specific multicast service. It
identifies the ports containing hosts requesting a service and sends data
out to those ports only. It then propagates the service request up to any
neighboring multicast switch/router to ensure that it will continue to
receive the multicast service.
IGMP Snooping Commands
Table 4-69 Multicast Filtering Commands
Command Groups Function Page
IGMP Snooping Configures multicast groups via IGMP snooping
or static assignment, sets the IGMP version,
displays current snooping and query settings, and
displays the multicast service and group
members
4-276
IGMP Query Configures IGMP query parameters for
multicast filtering at Layer 2
4-280
Static Multicast
Routing
Configures static multicast router ports 4-285
Table 4-70 IGMP Snooping Commands
Command Function Mode Page
ip igmp snooping Enables IGMP snooping GC 4-277
ip igmp snooping vlan
static
Adds an interface as a member of a
multicast group
GC 4-277
ip igmp snooping
version
Configures the IGMP version for
snooping
GC 4-278
show ip igmp snooping Shows the IGMP snooping and query
configuration
PE 4-279
show
mac-address-table
multicast
Shows the IGMP snooping MAC
multicast list
PE 4-279