Gigabit Ethernet Switch Management Guide

C OMMAND L INE I NTERFACE
4-236
Editing VLAN Groups
vlan database
This command enters VLAN database mode. All commands in this mode
will take effect immediately.
Default Setting
None
Command Mode
Global Configuration
Command Usage
• Use the VLAN database command mode to add, change, and delete
VLANs. After finishing configuration changes, you can display the
VLAN settings by entering the show vlan command.
•Use the interface vlan command mode to define the port
membership mode and add or remove ports from a VLAN. The
results of these commands are written to the running-configuration
file, and you can display this file by entering the show
running-config command.
Configuring Private
VLANs
Configures private VLANs, including uplink and
downlink ports
4-247
Configuring Protocol
VLANs
Configures protocol-based VLANs based on
frame type and protocol
4-247
Table 4-57 Editing VLAN Groups
Command Function Mode Page
vlan database Enters VLAN database mode to add,
change, and delete VLANs
GC 4-236
vlan Configures a VLAN, including VID,
name and state
VC 4-237
Table 4-56 VLAN Commands (Continued)
Command Groups Function Page