Gigabit Ethernet Switch Management Guide

I NTERFACE C OMMANDS
4-173
Interface Commands
These commands are used to display or set communication parameters for
an Ethernet port, aggregated link, or VLAN.
Table 4-45 Interface Commands
Command Function Mode Page
interface Configures an interface type and
enters interface configuration mode
GC 4-174
description Adds a description to an interface
configuration
IC 4-174
speed-duplex Configures the speed and duplex
operation of a given interface when
autonegotiation is disabled
IC 4-175
negotiation Enables autonegotiation of a given
interface
IC 4-176
capabilities Advertises the capabilities of a given
interface for use in autonegotiation
IC 4-177
flowcontrol Enables flow control on a given
interface
IC 4-178
media-type Force port type selected for
combination ports
IC 4-179
shutdown Disables an interface IC 4-180
switchport broadcast
packet-rate
Configures the broadcast storm
control threshold
IC 4-181
clear counters Clears statistics on an interface PE 4-182
show interfaces status Displays status for the specified
interface
NE, PE 4-183
show interfaces
counters
Displays statistics for the specified
interfaces
NE, PE 4-184
show interfaces
switchport
Displays the administrative and
operational status of an interface
NE, PE 4-186