Gigabit Ethernet Switch Management Guide

DNS C OMMANDS
4-163
DNS Commands
These commands are used to configure Domain Naming System (DNS)
services. You can manually configure entries in the DNS domain name to
IP address mapping table, configure default domain names, or specify one
or more name servers to use for domain name to address translation.
Note that domain name services will not be enabled until at least one name
server is specified with the ip name-server command and domain lookup
is enabled with the ip domain-lookup command
Privacy Protocol The privacy protocol used with SNMPv3.
Storage Type The storage type for this entry.
Row Status The row status of this entry.
Table 4-44 DNS Commands
Command Function Mode Page
ip host Creates a static host name-to-address
mapping
GC 4-164
clear host Deletes entries from the host
name-to-address table
PE 4-165
ip domain-name Defines a default domain name for
incomplete host names
GC 4-166
ip domain-list Defines a list of default domain names for
incomplete host names
GC 4-167
ip name-server Specifies the address of one or more name
servers to use for host name-to-address
translation
GC 4-168
ip domain-lookup Enables DNS-based host name-to-address
translation
GC 4-169
show hosts Displays the static host name-to-address
mapping table
PE 4-170
Table 4-43 show snmp user - display description
Field Description