Gigabit Ethernet Switch Management Guide

C ONFIGURING THE S WITCH
3-54
CLI – Use the snmp-server user command to configure a new user name
and assign it to a group.
Configuring SNMPv3 Groups
An SNMPv3 group sets the access policy for its assigned users, restricting
them to specific read and write views. You can use the pre-defined default
groups or create new groups to map a set of SNMP users to SNMP views.
Command Attributes
• Group Name – The name of the SNMP group. (Range: 1-32 characters)
• Model – The group security model; SNMP v1, v2c or v3.
• Level – The security level used for the group:
- noAuthNoPriv – There is no authentication or encryption used in
SNMP communications.
- AuthNoPriv – SNMP communications use authentication, but
the data is not encrypted (only available for the SNMPv3 security
model).
- AuthPriv – SNMP communications use both authentication and
encryption (only available for the SNMPv3 security model).
• Read View – The configured view for read access.
(Range: 1-64 characters)
• Write View – The configured view for write access.
(Range: 1-64 characters)
Console(config)#snmp-server user chris group r&d v3 auth md5
greenpeace priv des56 einstien 4-161
Console(config)#exit
Console#show snmp user 4-162
EngineId: 800000ca030030f1df9ca00000
User Name: chris
Authentication Protocol: md5
Privacy Protocol: des56
Storage Type: nonvolatile
Row Status: active
Console#