TigerSwitch 10/100 8-Port Fast Ethernet Switch Management Guide SMC6709L2

S WITCH S TATIC C ONFIGURATION M ENU
4-13
Configuring the IP Address
Use the IP Configuration page to configure the switch’s IP parameters.
Field Attributes
• IP Address – IP address of the switch. Valid IP addresses consist of four
numbers, 0 and 255, separated by periods. Anything outside this format
will not be accepted by the configuration program.
• Subnet Mask – Subnet mask of the switch. This mask identifies the host
address bits used for routing to specific subnets.
• Gateway – Gateway used to pass trap messages from the system’s agent
to the management station. Note that the gateway must be defined if the
management station is located in a different IP segment.
Console – Click Switch Static Configuration
=> Administration
Configuration
=> IP Configuration. Specify the IP address and other
parameters. Save your changes, and then reboot the switch to enable the
new settings.
TigerSwitch 10/100 : IP Configuration
=====================
IP Address : 10.1.0.4
Subnet Mask : 255.255.255.0
Gateway : 10.1.0.253
actions-> <Edit> <Save> <Quit>
Select the action menu.
Arrow/TAB/BKSPC = Move Item Quit = Previous menuu Enter = Select Itemm