Network Router User Manual

BACK - Equipment Checklist NEXT - Utility Installation
SMC2655W: Installation Instructions
1) Site Location – Choose a location for your SMC2655W Wireless Access Point. Usually, the best location is
at the center of your wireless coverage area, if possible within line-of-sight of all wireless devices.
2) Placement - Put the Access Point in a position that gives it maximum coverage. Normally, the higher you
place the antenna, the better the performance.
3) Connect the Ethernet cable – The SMC2655W can be wired to an Ethernet network through an Ethernet
device such as a hub or a switch using category 3, 4, or 5 UTP Ethernet cable and an RJ-45 connector.
4) Connect the power cable – Connect the power adapter cable to the 5 VDC power socket on the rear
panel.
Warning: Use only the power adapter supplied with the SMC2655W.