Network Router User Manual

Figure 1.2
Restore to Factory Defaults Procedure
1) Locate the [Default] button on the back of the SMC2655W Access Point.
2) Unplug the power from the back of the AP for 10 seconds.
3) Depress the [Default] button for 3 seconds.
4) Plug the power connector into the AP while depressing the [Default] button.
5) Release the [Default] button after 3 seconds. Wait 3 seconds and then depress the [Default] button again.
6) The "LNK/ACT" and "TX/RX" LEDs will blink once per second about 10-12 times. Release the [Default]
button when these LEDs begin flashing rapidly.