Network Adapter User Guide

8. Turn off your computer.

9. Insert the EZ Connect™ N Wireless PCI Adapter in to an available PCI slot. IMPORTANT: For

correct installation of new hardware please refer to your Computer user manual. NOTE: To install

the card you may be required to remove the attached antennas. This is done by pulling the

antennas from the base.

10. Once the EZ Connect™ N Wireless PCI Adapter is inserted screw on the larger 5dBi antenna to the

connector marked with a green sticker. If you had to remove the antennas in step 9 reconnect them

now. The antennas push on (not screw on) to the remaining connectors.

11. Turn On your computer.

12. The “Found New Hardware Wizard” will appear. Click [No, not this time], then Next].

13. Click [Install the software automatically (Recommended)], then click [Next].