Steps to configure SMCWTVG Analog Telephone Adaptor Configuration Guide
Overview This guide shows how to configure SMCWTVG Analog Telephone Adaptor (ATA) so you can use the Owtalk service. But first you must be an Owtalk subscriber. SMC ATA can be available in preconfigured mode, labeled as Owtalk Preconfigured on the surface of the packaging box. Under the preconfigured mode, all Owtalk SIP account information are pre-programmed, you don’t need to go through the following procedures. Please refer to Appendix A on how to activate an Owtalk preconfigured device.
Open Internet Explorer (or any other) web browser on your computer. Enter the default IP address of the ATA in the address field. Please type 5 http://192.168.0.109 in the address field. Enter smcamdin in the field of Password. Click Login. 6 Click VOIP and then SIP Settings to enter the SIP Configuration. The configuration information is available in the self-configuration tab in 7 Owtalk after sign-up or click View SIP Account Configuration in Owtalk My Account page.
8 The SIP port number is set at 6060. For the remaining tabs, you can accept the default settings, or you change them to suit your setup. And then click Save and Apply. 9 After the ATA set up procedure is complete, the device is ready for use and you can now receive and make outgoing calls.
Appendix A Owtalk Preconfigured SMC ATA To activate your Owtalk preconfigured device, you need to obtain an activation number. Go to My Account after sign-up for Owtalk at http://www.owtalk.com. Press Port to Preconfigured and click Next to get the activation number. Simply dial the activation number after connecting your ATA to your cable/ADSL modem, router, or broadband Internet connection. Your ATA is then all set and ready for use.
