User's Manual
iv
JI5-RT359333DB5 User Manual
IMPORTANT
NOTE
:
FCC
Radiation Exposure
S
t
ateme
n
t:
This equipment complies with FCC radiation exposure limits set forth for
an
uncontrolled environment.
This equipment should be installed and
operated
with minimum distance 20cm between the radiator &
your
body.
This transmitter must not be co-located or operating in conjunction with any other antenna
or transmitter.
IEEE 802.11 a/n operation of this product in the U.S.A.
is
firmware-limited to channels 1 through
11.
This device is
intended
only for OEM
integrators
under the
following condition
s:
The antenna must be installed such that 20 cm is maintained between
the
antenna and users,
and
The transmitter module may not be co-located with any other transmitter
or antenna.
As long as the above two conditions are met, further transmitter test will not
be
required. However, the
OEM integrator is still responsible for testing
their
end-product for any additional compliance
requirements required with
this
module installed (for example, digital device emissions, PC
peripheral
requirements,
etc.).
IMPORTANT NOTE: In the event that these conditions can not be met
(for
example certain laptop
configurations or co-location with another
transmitter),
then the FCC authorization is no longer
considered valid and the FCC ID
can
not be used on the final product. In these circumstances, the OEM
integrator
will be responsible for re-evaluating the end product (including the
transmitter)
and obtaining
a separate FCC
authorization.
注意
!
依據
低功率電波輻射性電機管理辦法
第十二條
經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用
者均不得擅自
變更頻率、加大功率或變更原設計之特性及功能。
第十四條
低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現
有干擾現象時，
應立即停用，並改善至無干擾時方得繼續使用。
前項合法通信，指依電信規定作業之無線電信。
低功率射頻電機
須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干
擾。