User's Manual

v
SMCD3GNV5 Administrator Manual
第十四條
低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現 有干擾現象
時，應立即停用，並改善至無干擾時方得繼續使用。
前項合法通信，指依電信規定作業之無線
電信。低 功 率 射 頻 電 機
須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干 擾。
End Product
Labeling
This transmitter module is authorized only for use in device where the
antenna may be installed
such that 20 cm may be maintained between the antenna and users. The final end product must be
labeled in a visible area with the
following: “Contains TX FCC ID: JI5-359333DB24 ”.
Manual Information That Must be Included
This module must be properly installed in an approved device to function properly.Installation should
be performed only at the factory or by a qualified service technician.The module should be inserted
into the mini-PCIE connector. Once installed into the mini-PCIE card slot, carefully attach the Wi-Fi
antennas to the connectors on the card.
The OEM integrator has to be aware not to provide information to the end
user regarding how to
install or remove this RF module in the user manual of
the end product which integrates this module.
The user manual for OEM integrators must include the following information
in a prominent location
“IMPORTANT NOTE: To comply with FCC RF
exposure compliance requirements, the antenna
used for this transmitter must
be installed to provide a separation distance of at least 20 cm from all
persons
and must not be co-located or operating in conjunction with any other antenna or transmitter.
For all the model ship to USA market, OEM integrator shall limit the accessible
channel to US
channel 1 -11 only during the manufacturing process by special firmware
setting which is not
available to the end
user.