User's Manual

iv
SMCD3GNV5 Administrator Manual
IMPORTANT
NOTE :
FCC
Radiation Exposure S t ateme n t:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and
operated with minimum distance 20cm between the radiator &
your
body.
This transmitter must not be co-located or operating in conjunction with any other antenna
or transmitter.
IEEE 802.11b/g/n operation of this product in the U.S.A.
is firmware-limited to channels 1 through 11.
This device is
intended only for OEM integrators under the following condition s:
• The antenna must be installed such that 20 cm is maintained between
the antenna and users, and
• The transmitter module may not be co-located with any other transmitter
or antenna.
As long as the above two conditions are met, further transmitter test will not
be required. However,
the OEM integrator is still responsible for testing
their end-product for any additional compliance
requirements required with
this module installed (for example, digital device emissions, PC peripheral
requirements, etc.).
IMPORTANT NOTE: In the event that these conditions can not be met
(for example certain laptop
configurations or co-location with another transmitter), then the FCC authorization is no longer
considered valid and the FCC ID
can not be used on the final product. In these circumstances, the
OEM
integrator will be responsible for re-evaluating the end product (including the transmitter) and
obtaining a separate FCC authorization.
注意
!
依據
低功率電波輻射性電機管理辦法
第十二條
經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用 者均不得擅自
變更頻率、加大功率或變更原設計之特性及功能。