User's Manual

Installing the Security System
Page 60 | August 17, 2010
Table 7: Manage Camera Operations
Operations
Description
Modify a camera Change the name identifying each camera in the TouchScreen and the
Subscriber Portal.
Set or modify the zone to which the camera is assigned. When a camera is
assigned to a zone, the camera takes a series of pictures if that zone trips an
alarm.
Delete the camera
from the security
system
Remove a camera from being managed by the
TouchScreen (see page 104).
Use these actions in
sequence to reset a
sensor’s IP/MAC
addresses to factory
default
Add a camera to the
security system
Add an additional camera to the TouchScreen –
up
to six (see page 96)
Replace a camera Swap the current camera with another one (see page 104)
Table 8: Manage Peripheral Operations
Operation
Description
Delete a key fob Remove a key fob from being able to access the
security system (see page 110).
Use these actions in
sequence to reset a key
fob’s details to factory
default.
Add a key fob Find a new key fob that is available to be added
(see page 106).
Modify a key fob Change the name identifying each key fob in the TouchScreen and the
Subscriber Portal. (see page 109).
Delete a key pad Remove a key pad from being able to access the
security system (see page 117).
Use these actions in
sequence to reset a key
pad’s details to factory
default.
Add a key pad Find a new key pad that is available to be added
(see page 112).
Modify a key pad Change the name identifying each key pad in the TouchScreen and the
Subscriber Portal (see page 115).