User's Manual

Installing the Security System
Page 58 | August 17, 2010
L. Configuring the TouchScreen
If necessary, perform the following operations:
• Modify the Entry and Exit delay time periods (see page 69)
• Modify the alarm transmission delay (see page 71)
• Modify the “swinger shutdown” (see page 73)
Reset the TouchScreen to factory defaults (see page 73)
Note: This will cause the device to require activation again, which in turn will require that the
customer’s account be reset as well.
• Check for a new firmware update (see page 76)
• Manage the sensors/security zones (see Table 6 on page 59)
• Manage key fobs and key pads (see Table 8 on page 60)
• Manage the cameras (see Table 7 on page 60)
Technicians can also perform the following general activities that are also available to the customer.
Note: See the TouchScreen User Guide for information about these activities.
§ Manage the Quickarm settings
§ Manage the way sensors are listed in TouchScreen reports and tools
§ View and test the TouchScreen’s connectivity to the central monitoring stations (also
described in this document on page 16)
§ Manage the keypad codes and secret word
§ View the customer’s account information
§ Manage your TouchScreen device sounds, screensaver, etc
§ View technical information about the TouchScreen device