Tape Driver User's Guide

ManualsBrandsSMC Networks ManualsCassette PlayerM8501

Troubleshooting

M8501 and M8502 ACL Tape Drive Installation and User’s Guide—529972-001

6-12

Fault Symptom Codes (FSCs)

SMX send error A001 C, G An attempt to place a message on a

task’s exchange generated a kernel error.

SMX receive error A002 C, G An attempt to receive a message from a

task’s exchange generated a kernel error.

Comm free list empty A003 C, G An attempt to acquire a message from the

free pool failed because the pool is empty.

Invalid comm. put

attempt

A004 C, G An attempt to place a message on a

task’s exchange failed because either the

argument message pointer was NULL or

the argument exchange pointer was

NULL.

Invalid comm. get

attempt

A005 C, G An attempt to receive a message from a

task’s exchange failed because the

argument exchange pointer was NULL.

Comm initialization

error

A006 C, G The Comm manager could not be

initialized at power-up because the

system is out of memory.

Put of a NULL comm. A007 C, G An attempt to place a Comm block on a

task’s exchange failed the argument

Comm block pointer was NULL.

Msg contains no

comm.

A008 C, G A message obtained from the free pool

did not contain a Comm block.

Comm return address

in unknown

A009 C, G An attempt to return a command

response to the originating task failed

because the originator could not be

determined.

Bad Image CRC F001 F The uploaded firmware image has a bad

CRC and is probably corrupted.

Flash erase sector

failed

F002 F One of the flash memory sectors could

not be programmed.

Flash program sector

failed

F003 C, G One of the flash memory sectors could

not be erased.

Bad flash CRC F004 C, G The firmware image programmed into

flash memory has a bad CRC and is

probably corrupted.

Flash exit error F005 C, G Internal flash task error.

Incompatible image F006 F The uploaded firmware image is not

compatible with the ACL hardware,

possibly an older firmware version.

Buffer allocation failed F402 F The flash task could not allocate a buffer

area to hold the firmware image to be

uploaded.

Table 6-2. Fault Symptom Codes

Message FSC ERP