Manual
Table Of Contents
- ANSI C63.17-2006 Front Cover
- Title page
- Introduction
- Notice to users
- Participants
- Contents
- American National Standard Methods of Measurement of the Electromagnetic and Operational Compatibility of Unlicensed Personal Communications Services (UPCS) Devices
- 1. Overview
- 2. Normative references
- 3. Definitions, symbols, acronyms, and abbreviations
- 4. Radiated and conducted emissions test methodology
- 4.1 Test facilities and equipment
- 4.2 Test configurations and setup
- 4.3 Transmitted power and monitoring threshold limits
- 4.4 Limits for radiated and conducted tests
- 4.5 Conducted measurements of products with identical collocated transmitting and monitoring antennas
- 4.6 Conducted measurements of products with collocated transmitting and monitoring antennas of different types
- 4.7 Conducted measurements of products with arbitrarily placed transmitting and monitoring antennas
- 4.8 Radiated measurements of products with identical collocated transmitting and monitoring antennas
- 4.9 Radiated measurements of products with collocated transmitting and monitoring antennas of different types
- 4.10 Radiated measurements of products with arbitrarily placed transmitting and monitoring antennas
- 4.11 Manufacturer’s declarations and descriptions
- 5. Measurement instrumentation
- 6. RF measurements
- 7. Monitoring tests
- 8. Time and spectrum window access procedure
- 9. Test report
- 9.1 Test report contents
- 9.2 Applicable standards
- 9.3 Equipment units tested
- 9.4 Test configuration
- 9.5 List of test equipment
- 9.6 Units of measurement
- 9.7 Location of test site
- 9.8 Measurement procedures
- 9.9 Reporting measurement data
- 9.10 General and special conditions
- 9.11 Summary of results
- 9.12 Required signatures
- 9.13 Test report appendixes
- 9.14 Test report disposition
- Annex A (informative) 47CFR15, Subpart D—Rules and test cases for UPCS devices
- Annex B (informative) Radiated and conducted measurement of power output and monitoring thresholds
- Annex C (informative) Options for implementing the tests of Clause 7 and Clause 8
American National Standard
Methods of Measurement of the
Electromagnetic and Operational
Compatibility of Unlicensed Personal
Communications Services (UPCS)
Devices
1.
1.1
1.2
Overview
Scope
This standard sets forth uniform methods of measurement of the electromagnetic and operational
compatibility of unlicensed personal communications services (UPCS) devices. This standard does not
cover licensed personal communications services (PCS) devices. The recommended methods are applicable
to the radio transmitter and monitoring devices contained in the UPCS device. These methods apply to the
measurement of individual UPCS devices. Additional methods may be added to this standard to fulfill
future requirements.
In addition to the measurements specified herein, UPCS devices may also be required to be tested in
accordance with other standards. Examples are listed in Annex A.
Applications
The procedures given herein may be used to test UPCS devices permitted under 47CFR15, Subpart D.
1
The
emissions and operational characteristics of UPCS devices are the basic parameters affecting UPCS
coexistence with other electronic devices and systems. In particular, compliance with this standard may be
used to demonstrate electromagnetic compatibility with other UPCS systems and other systems operating in
the same and adjacent frequency bands.
1
For information on references, see Clause 2.
1
Copyright © 2007 IEEE. All rights reserved.
Licensed to Sid Sanders. ANSI order X_30788. Downloaded 11/19/2007 2:45 PM. Single user license only. Copying and networking prohibited.