Manual
Table Of Contents
- ANSI C63.17-2006 Front Cover
- Title page
- Introduction
- Notice to users
- Participants
- Contents
- American National Standard Methods of Measurement of the Electromagnetic and Operational Compatibility of Unlicensed Personal Communications Services (UPCS) Devices
- 1. Overview
- 2. Normative references
- 3. Definitions, symbols, acronyms, and abbreviations
- 4. Radiated and conducted emissions test methodology
- 4.1 Test facilities and equipment
- 4.2 Test configurations and setup
- 4.3 Transmitted power and monitoring threshold limits
- 4.4 Limits for radiated and conducted tests
- 4.5 Conducted measurements of products with identical collocated transmitting and monitoring antennas
- 4.6 Conducted measurements of products with collocated transmitting and monitoring antennas of different types
- 4.7 Conducted measurements of products with arbitrarily placed transmitting and monitoring antennas
- 4.8 Radiated measurements of products with identical collocated transmitting and monitoring antennas
- 4.9 Radiated measurements of products with collocated transmitting and monitoring antennas of different types
- 4.10 Radiated measurements of products with arbitrarily placed transmitting and monitoring antennas
- 4.11 Manufacturer’s declarations and descriptions
- 5. Measurement instrumentation
- 6. RF measurements
- 7. Monitoring tests
- 8. Time and spectrum window access procedure
- 9. Test report
- 9.1 Test report contents
- 9.2 Applicable standards
- 9.3 Equipment units tested
- 9.4 Test configuration
- 9.5 List of test equipment
- 9.6 Units of measurement
- 9.7 Location of test site
- 9.8 Measurement procedures
- 9.9 Reporting measurement data
- 9.10 General and special conditions
- 9.11 Summary of results
- 9.12 Required signatures
- 9.13 Test report appendixes
- 9.14 Test report disposition
- Annex A (informative) 47CFR15, Subpart D—Rules and test cases for UPCS devices
- Annex B (informative) Radiated and conducted measurement of power output and monitoring thresholds
- Annex C (informative) Options for implementing the tests of Clause 7 and Clause 8
8. Time and spectrum window access procedure ......................................................................................... 31
8.1 Timing for EUTs using control and signaling channel-type transmissions ....................................... 32
8.2 Timing for EUTs using communications channel-type transmissions............................................... 34
8.3 Duplex connections ........................................................................................................................... 35
8.4 Alternative monitoring interval ......................................................................................................... 39
9. Test report................................................................................................................................................. 39
9.1 Test report contents ........................................................................................................................... 39
9.2 Applicable standards.......................................................................................................................... 39
9.3 Equipment units tested....................................................................................................................... 40
9.4 Test configuration.............................................................................................................................. 40
9.5 List of test equipment ........................................................................................................................ 40
9.6 Units of measurement........................................................................................................................ 40
9.7 Location of test site............................................................................................................................ 40
9.8 Measurement procedures ................................................................................................................... 40
9.9 Reporting measurement data ............................................................................................................. 40
9.10 General and special conditions ........................................................................................................ 41
9.11 Summary of results.......................................................................................................................... 41
9.12 Required signatures ......................................................................................................................... 41
9.13 Test report appendixes..................................................................................................................... 41
9.14 Test report disposition ..................................................................................................................... 41
Annex A (informative) 47CFR15, Subpart D—Rules and test cases for UPCS devices.............................. 42
Annex B (informative) Radiated and conducted measurement of power output and monitoring
thresholds............................................................................................................................................ 50
B.1 General.............................................................................................................................................. 50
B.2 Power limits ...................................................................................................................................... 51
B.3 Transmit power and monitoring threshold test method selection ..................................................... 52
B.4 General guidelines on measurement conditions and procedures....................................................... 54
Annex C (informative) Options for implementing the tests of Clause 7 and Clause 8................................. 55
C.1 Multicarrier interference generator ................................................................................................... 55
C.2 General.............................................................................................................................................. 55
C.3 Alternative approaches...................................................................................................................... 59
viii
Copyright © 2007 IEEE. All rights reserved.
Licensed to Sid Sanders. ANSI order X_30788. Downloaded 11/19/2007 2:45 PM. Single user license only. Copying and networking prohibited.