User's Manual

錯誤
錯誤錯誤
錯誤! 使用
使用使用
使用 [常用
常用常用
常用] 索引標籤
索引標籤索引標籤
索引標籤將
將將
將 Heading 1 套用到您想要在此處顯示的文字
套用到您想要在此處顯示的文字套用到您想要在此處顯示的文字
套用到您想要在此處顯示的文字。
。。
。
48
SMCD3GNV Wireless Cable Modem Gateway User Manual
Table 6. Local IP Configuration Menu
Option Description
IPv4
(for computers that use IPv4 Messaging)
Gateway Address IPv4 IP address that the Gateway is to use.
Subnet Mask IPv4 subnet mask that the Gateway is to use.
DHCP Beginning Address Starting IP address range for the pool of allocated for DHCP IP addresses. The first two fields
match the first two octets in the Gateway’s IP address and cannot be changed. The last two
fields let you enter the final two octets in the starting IP address range.
DHCP Ending Address Ending IP address range for the pool of allocated for DHCP IP addresses. The first two fields
match the first two octets in the Gateway’s IP address and cannot be changed. The last two
fields let you enter the final two octets in the ending IP address range.
DHCP Lease Time Amount of time a DHCP network user is allowed connection to the Gateway with their current
dynamic IP address. Default is One Week.
SAVE SETTINGS button After configuring your IPv4 settings, click this button to save them.
RESTORE DEFAULT SETTINGS
FOR IPV4 button
Resets the Gateway to the factory default IPv4 settings.
IPv6
(for computers that use IPv6 Messaging)
Enable IPv6 Check this box to configure the Gateway to use IPv6 settings.
Gateway Address IPv6 IP address that the Gateway is to use.
Subnet Mask IPv6 subnet mask that the Gateway is to use.
DHCP Beginning Address Starting IP address range for the pool of allocated for DHCP IP addresses. The first two fields
match the first two octets in the Gateway’s IP address and cannot be changed. The last two
fields let you enter the final two octets in the starting IP address range.
DHCP Ending Address Ending IP address range for the pool of allocated for DHCP IP addresses. The first two fields
match the first two octets in the Gateway’s IP address and cannot be changed. The last two
fields let you enter the final two octets in the ending IP address range.
DHCP Lease Time Amount of time a DHCP network user is allowed connection to the Gateway with their current
dynamic IP address. Default is One Week.
IPv6 Mode Select the IPv6 mode that the Gateway is to use. Choices are:
• link-local only = allows communication among nodes attached to the same link. Packets
are not forwarded outside the site. ( default )
• site-local only = allows communication among nodes within a site or organization.
SAVE SETTINGS button After configuring your IPv6 settings, click this button to save them.
RESTORE DEFAULT SETTINGS
FOR IPV6 button
Resets the Gateway to the factory default IPv6 settings.