OWNERS MANUAL Hub/Switch 48-Port

A BOUT THE T IGER S WITCH 10/100
1-4
Status LEDs
The LEDs, which are located on the front panel for easy viewing,
are shown below and described in the following table.
Port and System Status LEDs
LED Condition Status
Power On Switch is receiving power.
RDP On Redundant power is on, and the RPU is in
backup or active mode.
Off Redundant power is off or has failed.
Mgmt On Agent is operational.
RJ-45 Ports
Link On Amber Port has established a valid 10 Mbps
connection.
On Green Port has established a valid 100 Mbps
connection.
Flashing Port has been partitioned due to an
abnormal network condition, or manually
disabled.
Act* On Traffic is passing through the port.
FDX* On Port is operating at full duplex.
Off Port is operating at half duplex.
FC* On Flow control enabled.
* Use the Mode Select button to select the LED display mode.