OWNERS MANUAL Hub/Switch 24/16

ROUBLESHOOTING

1. Symptom

Power LED does not light after power on.

Probable Causes

Power outlet or power cord may be defective.

Possible Solutions

• Check for loose connections.

• Check the power outlet by using it for another device.

• Replace the power cord.

2. Symptom

Link LED does not light after connection is made.

Probable Causes

Switch port, network card or cable may be defective.

Possible Solutions

• Check that the switch and attached device are both

powered on.

• Be sure the network cable is connected to both devices.

• Verify that Category 5 cable is used for 100 Mbps

connections and that the length of any cable does not

exceed 100 meters (328 feet).

• Check the network card and cable connections for defects.

• Replace the defective card or cable if necessary.

• For ST-type fiber module connections, ensure that the

transmit (Tx) port is connected to the receive port on the

other device.