Owners Manual Hub/Switch 16 10BASE-T, 100BASE-TX

Introduction
1-6
1
Port Configuration Admin Status Enabled
Auto-negotiation Enabled
Flow Control Disabled
Port Capability 100BASE-TX –
10 Mbps half duplex
10 Mbps full duplex
100 Mbps half duplex
100 Mbps full duplex
Full-duplex flow control disabled
Symmetric flow control disabled
Module Port Capability 100BASE -FX –
100 Mbps full duplex
Full duplex flow control disabled
Symmetric flow control disabled
1000BASE-T/SX/LX/LH –
1000 Mbps full duplex
Full-duplex flow control disabled
Symmetric flow control disabled
Rate Limiting Input and output limits Disabled
Port Trunking Static Trunks None
LACP (all ports) Disabled
Broadcast Storm
Protection
Status Enabled (all ports)
Broadcast Limit Rate 32,000 octets per second
Spanning Tree
Protocol
Status Enabled
(Defaults: All values based on IEEE 802.1w)
Fast Forwarding (Edge Port) Disabled
Address Table Aging Time 300 seconds
Virtual LANs Default VLAN 1
PVID 1
Acceptable Frame Type All
Ingress Filtering Disabled
Switchport Mode (Egress Mode) Hybrid: tagged/untagged frames
GVRP (global) Disabled
GVRP (port interface) Disabled
Table 1-2. System Defaults (Continued)
Function Parameter Default