Quick Start Guide
Ste
p
14 – Mounn
g
the s
y
stem
Alarm Panel
ocon:
Mounted the alarm panel close to the door which you normally use to enter/exit your
house.
e Alarm panel requires a power outleroperly.
Ensure the locected a good GSM signal. You can do this by cross checking the signal
bar on your phone
The panel must not be co-located or operated in conn with any other nearby
or antenna.
1. Remove the back panel mog bracket of the
GSM and mount the bracket on the wall using wall
anchors and screws.
2. Once secured, ensure the power conney and
h the alarm panel to the secured moung
bracket.
Door/Window contact
If possible, locate sensors withof the panel. While a transmier may have a range
06 m) or more out in the open, the environment at thee can have a
nt eect on trans
1. Mount the sensor on the door frame and the
magnet on the door. If the sensor is used on
double doors, mount the sensor on the least-
used door and the magnet on the most-used
door.
2. Place sensors at least (1.5 m) above the
best transmission range
3. Make sure the alignment arrow on the magnet
points to the alignment mark on the sensor.
4. Avoid mounng sensors i
n areas where they will
be exposed to moisture or high temperature.
5. Use spacers (not included) to keep sensors and
magnets away from metal or metallic surfaces
such as foil wallpaper.
PIR Moon Sensor
The recommended position for a PIR Detector is in the corner of a room mounted at a height between
1.8 and 2m. At this height, the detector will have a maximum range of up to 10m with a field of view of
110° (see figure below).
Keep sensors within 30 m (100 panel.
1. Fix the on sensor on the wall by using the
adhesive tape provided.
2. If you need to drill it on the wall, remove the rear
cover and drill through the rear cover. Drill guides
are provide font or corner mount (see
below)
3.
Once the back cover is secured reach the main
body of the sensor to the back cover.
9
1
3
5
7
Corner mounted
Drill for corner monuting
Drill for flat wall monuting