Quick Start Guide

Step 10 – Adding numbers for Alarm naon
1. ng, alerts and type the number in any of the available spaces.
2. Photo Id numbers for calling or SMS may be added.
Note: Adding a contact into the SMS list will also enable that
contact to have limited access of the GSM panel using the App.
They can Arm/Paral Arm/Disarm the system but do not have
access to other sengs.
1. s in the app, then tags, to rename RFID tags
2. Select the tag that you wish to customize.
3. Select a person from contact list including image and then enter the image
and name.
4. An SMS may be sent to nothe system change.
5. Press Zones to rename security accessories
6. Rename the zones according to the device lofor example “Main door”.
7. If the changes are successful, the user w SMS
It is advised to change the default system PI code
to prevent unauthorized any access to
your alarm panel.
1. To do so, on the alarm panel enter
2. hearing the beep, enter the new 4-digit  code +
3. To make sure the new PI code has been changed, try to arm the system.
4. The system should arm successfully using the new PI code.
Perform a quick teer the system has been set up and gured.
1. First Disarm the system using the App
2. Re-arm the system using the App
3. Trigger an alarm using the PIR and door/window detector.
4. Use the remote control to  the alarm once it has been triggered.
5. Check the noure that they are correct.
Note: To conserve its baery life, the PIR Moon sensor
can be triggered only once every 2 minutes.
Daily operaons from alarm panel:
noitcA krameR nocI nottuB noitcnuF
Arm  the alarm for monitoring. Enter (PI code) +
Disarm Deacvates the alarm.
Enter (PI code ) +
Ste
p
11 – Customize RFID and Zone names
Ste
p
13 – Final test before mounn
g
the s
y
stem
Ste
p
12 – Chan
g
e Default PIN code
1234 06
****
****