Operation Manual

16
4. ALARM STATION OPERATION
4.1 Arming the system
During the system arming, whatever will be the chosen mode, there will be an exit delay of 15 seconds.
The first 10 seconds will be silent, then there will be 1 beep every second, followed by a long beep at the
end of the delay to confirm arming.
The system has a total arming mode and a partial arming mode.
TOTAL ARMING: allows activation of all detectors
PARTIAL ARMING: enables only the detectors of area 1
Example:
The system can be configured in such a way that at night you arm only the lower floor detectors as well at
the entrance door and the garage, without to put into surveillance the upper floor detectors, so that you
can move freely without to trigger the alarm.
4.1.1 Total arming (area 1 and 2 active)
On the station:
- Enter 1234 (or your personal code), followed by 1.
On the remote control:
- Push the key
On the remote keyboard:
- Enter 1234 (or your personal code), followed by .
4.1.2 Partial arming (area 1 active and area 2 inactive)
On the station:
- Enter 1234 (or your personal code), followed by 2.
On the remote control:
- Push the key
On the remote keyboard:
- Enter 1234 (or your personal code), followed by .
4.2 Disarming the system
On the station:
- Enter 1234 (or your personal code), followed by 4.
On the remote control:
- Push the key
On the remote keyboard: