Operation Manual

15
3.3 Programming the phone transmitter
3.3.1 Programming the alert message
During a call, the station delivers a message that you must record beforehand. The message maximum duration is
6 seconds.
To record the message:
- Enter 1234 (or your personal code), followed by 5, the STATUS LED will flash.
- Stand 20-30 cm from the station and record your message.
- If your message lasts less than 6 seconds, push the key * to stop the recording.
To modify your message, just record a new message, which will replace the old one.
3.3.2 Programming phone numbers
You can save up to 4 phone numbers, which will be called one after the other, in the saving order, in the case of an
alarm.
To save the phone numbers:
- Enter 1234 (or your personal code), followed by 7, the STATUS LED will flash.
- Enter the correspondent phone number.
- End with *
- Follow the same procedure for the other numbers.
If you do not enter any number, the station will exit the programming mode automatically after 30 seconds.
3.3.3 Deleting phone numbers
The station cannot erase each number individually. If you want to erase a number, you must erase all of them.
This means that you must reprogram the phone numbers after resetting the memory.
To delete all phone numbers:
- In the station, enter 1234 (or your personal code), followed by 9, the STATUS LED will flash.
- Enter again 1234 (or your personal code), followed by 9, a long beep will be emitted to confirm the phone
number suppression.
The station exits the suppression mode automatically after 15 seconds or if you type 1234 (or your personal code),
followed by 4.