Operation Manual

14
3.2.3 Remote control learning
To program a remote control:
- Enter 1234 (or your personal code), followed by *, a long beep will be emitted
and the STATUS LED will flash.
- Push the remote control disarming button. When the signal is received, a long
beep will be emitted.
Note: You can learn at most 4 remote controls.
3.2.4 Deleting remote controls
The station cannot erase each remote control individually. If you want to erase a remote control, you must erase all
remote controls. This means that you must reprogram each remote control after resetting the memory.
To erase all remote controls:
- Enter 1234 (or your personal code), followed by #, a long beep will be emitted and the STATUS LED will flash.
- Enter again 1234 (or your personal code), followed by 4, a long beep will be emitted.
3.2.5 Remote keypad learning
To program the keyboard:
- Enter 1234 (or your personal code), followed by *, a long beep
will be emitted and the STATUS LED will flash.
- Push the self-protection key on the keyboard. When the signal is
received, a long beep will be emitted.
Note: Only one remote keyboard can be learned.
3.2.6 Deleting the remote keypad
To delete the remote keyboard:
- Enter 1234 (or your personal code), followed by #, a long beep will be emitted and the STATUS LED will flash.
- Enter again 1234 (or your personal code), followed by 5, a long beep will be emitted.
3.2.7 Deleting all accessories
You can delete all accessories saved in the station without to affect other programs.
To delete all accessories:
- Enter 1234 (or your personal code), followed by #, a long beep will be emitted and the STATUS LED will flash.
- Enter again 1234 (or your personal code), followed by 0, a long beep will be emitted.