Operation Manual

12
3.1.6 Alarm delay
It is about the working time of the built-in siren when an alarm is triggered. The delay can be set on 1, 2 or 3 minutes.
To change the alarm delay:
- Enter the factory code 1234 (or your personal code).
- Then push the keys 0 and then 4, a long beep will be emitted and the STATUS LED will flash.
- Choose the alarm delay.
- Push the key 1 for 1 minute OR the key 2 for 2 minutes OR the key 3 for 3 minutes, one confirmation beep will
be emitted.
NOTE: The alarm delay is 1 minute by default.
3.1.7 Frequency saturation
The station has a radio interference detection device on its frequency, for interferences likely to disturb connections
with its accessories.
To enable/disable the function:
- Enter the factory code 1234 (or your personal code).
- Then push the keys 0 and then 5, a long beep will be emitted and the STATUS LED will flash.
- Push the key 1 to enable OR the key 2 to disable the function, a confirmation beep will be emitted.
NOTE: The frequency saturation function is disabled by default.
3.1.8 Key beeps
You can disable the station key beeps by typing 1234 (or your personal code), followed by 8.
To reactivate beeps, you just have to follow the same procedure.
NOTE: The key beep function is enabled by default.