Operation Manual

11
Programming the station
3.1.3 Programming the personal code
A personal code must be saved first by using the alarm station keys. You must choose this code, it will be used to
enable or disable the system. To change the code:
- Enter the factory code 1234.
- Then push the key 6, a long beep will be emitted and the STATUS LED will flash.
- Enter your 4 digit personal code.
- Push the key 6 to confirm the code change, a long beep will be emitted to confirm that the code has
changed.
To modify your code again, repeat the previous instructions, but replace the factory code by your personal code.
3.1.4 Setting the trigger mode
The station allows you to choose between 2 triggering modes in the case of an alarm.
Mode #1: Siren + transmitter Enter 1234 (or your personal code), followed by 0 and then 1.
In this mode, in the case of an alarm, the station rings and the transmitter will call the programmed numbers (for
programming the built-in transmitter, go to page 15).
Mode #2: Silent mode/transmitter alone
Enter 1234 (or your personal code), followed by 0 and then 2.
In this mode, in the case of an alarm, the station will not ring, but the transmitter will call the programmed numbers
(for programming the built-in transmitter, go to page 15).
NOTE: Mode 1 is default mode.
3.1.5 Entry delay
This mode allows selecting if the station integrates a 15 seconds entry delay, between detection and the alarm
triggering.
To enable/disable the entry delay:
- Enter the factory code 1234 (or your personal code).
- Then push the keys 0 and then 6, a long beep will be emitted and the STATUS LED will flash.
- Push the key 1 to enable OR the key 2 to disable the entry delay, a confirmation beep will be emitted.
The exit delay is fixed to 15 seconds and cannot be modified.
NOTE: The entry delay is disabled by default.