Operation Manual

Page 33
【Record】Set recording status. There are three statuses: Configured, manual, and off；
Schedule: Snap in accordance to the recording types (general, test and alarm) and
defined time period;
Manual: Regardless the current status of the channel, select “Manual” will start general
snapshot on corresponding channels；
Stop: Regardless the current status of the channel, select “Stop” will stop snapshooting on
the corresponding channels；
【Time Period】Set time period for general recording. Image storage function will be activated only in
the defined time range；
【Type】Set types. There are three types：general, test, and alarm.
【Recording Type】Set recording types. There are three types：general, test, and alarm.
Regular: Keep taking snapshots in the defined time period
Detect: During specified time range, trigger “motion detection”, “video masking”, and
“video loss” alarm signals. The corresponding alarm settings will turn on the
snapshot function and start snapshot when receiving test signals.
Alarm: In specified time period, trigger the external alarm signal. "Alarm Input” setting will
turn on the snapshot function and start test snapshot when alarm signal is received.
Note: For “Alarm Function” settings, refer to Alarm Function section in Chapter 4.3.
4.2.3 Video Playback
See Chapter 3.5.2 Video Playback.
4.2.4 Video Backup
Backup DVR video files to an external storage device through this setting.
Note: Install a storage device for file backup before the operation; if the backup is terminated, files
already copied to the storage device can be played back independently.
If the backup is terminated, files already copied to the storage device can be played back
independently.