Operation Manual

Page 20
Figure 3.9 Alarm Output
【Configuration】Generates alarm signals in accordance with the configuration；
【Manual】Regardless of the current status of the channel, selecting “Manual” will generate alarm
signals on the corresponding channel；
【STOP】Regardless of the current status of the channel, selecting “STOP” will stop the output of
alarm signals on the corresponding channel.
3.5.5 PTZ Control
Control Pan/Tilt/Zoom connected to the device. Use desktop quick launch to enter the menu.
Control interface is shown as in Figure 3.10. Functions supported: Control PTZ directions, step
length, zoom, focus, aperture, operating preset, point-to-point patrol, trace, boundary line scanning,
auxiliary switch, light switch, and horizontal rotation.
Note 1. Before operating, make sure the A/B cables of the dome are properly connected to the DVR
A/B jacks；
2. Setup PTZ parameters in 【Main Menu】>【System Setup】>【PTZ Setup】；
3. Functions supported by PTZ depend on the features supported by PTZ protocol.
Figure 3.10 PTZ Control