Operation Manual

Installation
As the battery may not be fully charged out of the box, it is recommended to plug the doorbell into the
mains using the pre-installed power cable and power supply during set-up. The main button will light up
white during charging.
The power cable comes pre-installed to easy set-up out of the box. You can keep this connected and
keep the doorbell powered from the mains or you can remove it for full wire free use and charge the
doorbell every 4-6 months depending on use. To remove the power cable unscrew the rear cover and
disconnect from the doorbell.
Alternatively, you can also charge the unit using the Micro-USB cable and connect this to the
charger port at the bottom of the doorbell when required.
Doorbell setup
1. Remove the wall fixing base by using the supplied screwdriver to loosen the security screw at
the base of the doorbell then slide the base plate down and off the doorbell.
2. Pull the charger port cover open.
3. Pull the front cover off the doorbell by pulling the bottom first. You can use a blunt tool to help
you with this. This will reveal the power and re-set buttons at the bottom of the doorbell.